Problem: 
Line builds up on one side of spool.
Cause & Solution: 
Worm gear or pawl dirty or damaged, clean and lube or replace worm gear.

Problem:
Cotinuous backlashes.
Cause & Solution. 
Cast control cap loose or Brake collars not set properly, adjust cap and/or brake collars.

Problem:
Braided line slips on spool.
Cause & Soloution:
No monofilament line on spool first. Put a few yards of monofiament line on spool first then the braided line.

Problem:
Spool will not turn when cranking.
Cause & Solution:
Star drag not properly tightened. Tighten star drag.

Problem:
Reel squeals when casting.
Cause & Solution:
Bearings dirty, worn, or lack lubrication. Clean bearings and add one drop of oil.

Problem:
Drag not holding:
Cause & Solution:
Drag has been left tight after use. Always loosen drag after each to prevent drag washers from flatening. Drag washes may be dirty or have oil or grease on them. Remove, clean or replace if necessary.

Problem:
Reel not casting normal distance.
Cause & Solution:
Spool tension too tight or washers worn. Internal parts have dirt and grease buildup. Clean or have reel cleaned and lubed properly. Super tuning a reel will add extra distance to cast.

Problem:
Gears are rough.
Cause & Solution:
Gears dirty or worn or lack proper lubrication. Remove gears, clean off old grease and dirt and regrease.







Modify Website

© 2000 - 2011 powered by
www.doteasy.com